Because of the possibility of injury, strictly follow
the replacement procedure below.
This product has a High Intensity Discharge (HID)
lamp that contains a small amount of mercury.
Disposal of these materials may be regulated
in your community due to environmental
considerations.
For disposal or recycling information please contact
your local authorities, or the Electronics Industries
Alliance:
Lamp replacement procedure
- Turn power off, wait until power
indicator stops blinking red, then
unplug the power cord from the
wall outlet and confirm that the area
around the lamp unit has cooled
down. - Remove the Front cover. Place your
fingertips under the Front cover and
pull it from the projection display. - Loosen the Lamp cover screw.
First read caution and warn ing
labels on lamp cover. Then, loosen
the lamp cover screw by using a
screwdriver. - Loosen the lamp unit screw with a
screwdriver. Then, grasp the lamp
unit as shown in the diagram, and
slowly remove from the projection
display - Insert the new lamp unit being careful
of the insertion direction.
• Press on the arrow mark making sure
insertion is done correctly - Replace the Lamp unit and cover
screws. Tighten the lamp unit/cover
screw with a screwdriver.
• Properly dispose of old lamp. Please see the
operating instructions for the projection display - Replace the Front cover.
